Setup, Compatibility & Care
Preparation is Key: Ensure the surface to be painted is clean, dry, and free from rust, grease, and old paint. For best adhesion, lightly abrade the surface with sandpaper if necessary, then wipe clean. For heavily rusted areas, use a wire brush or sandpaper to remove all loose material.
Application: Shake the can vigorously for at least two minutes before use. Hold the can upright, about 25-30cm (10-12 inches) from the surface. Apply in thin, even coats, using a steady back-and-forth motion. Avoid over-spraying. Allow at least 15-20 minutes between coats. It is recommended to apply multiple thin coats rather than one thick coat.
Curing: The paint will dry to the touch within 10-15 minutes, but full curing requires heat. It is essential to gradually introduce heat to the painted surface after it has dried for at least 24 hours. For stoves or BBQs, this can be achieved by operating them at low temperatures initially and gradually increasing the heat over several uses.
Compatibility: Suitable for metal surfaces that will be exposed to high temperatures, including barbecues, stoves, wood burners, fire pits, exhaust pipes, and engine components.
Care: Once fully cured, surfaces painted with this product can be cleaned using a damp cloth. Avoid abrasive cleaners or solvents that could damage the finish.