Plastic Waste Pipe Fitting - 36mm - 45 Degree - Solvent Weld Bend

You should use a solvent cement specifically designed for uPVC or plastic waste pipe systems. Always follow the cement manufacturer's instructions for application and curing.

No, this fitting is designed for solvent weld joints only and is not compatible with push-fit systems.

A 45-degree bend provides a smoother change in direction, which helps maintain a better flow rate for the waste and reduces the likelihood of material accumulating and causing blockages, especially in systems with frequent bends.

While suitable for domestic waste, it is primarily designed for cold and temperate wastewater. Prolonged exposure to very high temperatures may affect the plastic's integrity over time. Check specific temperature ratings if this is a concern.

Proper preparation is key. Ensure pipes and fittings are clean, dry, and cut squarely. Apply solvent cement liberally and evenly to both surfaces, then push the pipe into the fitting with a slight twist and hold for at least 30 seconds. Allow full curing time before use.

The fitting has a 36mm solvent weld connection, designed to fit 36mm outside diameter plastic waste pipe.

Ensure pipes were cut square, cleaned, and that solvent cement was applied evenly to both surfaces. Re-cut pipe and re-joint if necessary, ensuring adequate hold time during curing.

Check for obstructions inside the fitting or on the pipe end. Ensure the pipe is the correct 36mm diameter and that no burrs are present. A slight chamfer on the pipe end can aid insertion.

While the bend is designed for good flow, a blockage may be occurring further down the line. Ensure all pipework is correctly sloped and clear of obstructions. Check for any sharp angles or build-up within the system.