Best current price£12.79from eBay
Shopping.co.uk recommended and popular offers
eBay£12.79Visit shop Temperature Sensor NTC for BEKO BELLING BLOMBERG DE DIETRICH Washing Machine
Visit shop
B&Q£13.19Visit shop B&Q - Temperature Sensor Ntc Probe Compatible With Beko Washing Machine
Visit shop2 offers from £12.79 - £13.19
View price history by clicking the chart icon.
The SPARES2GO NTC temperature sensor is designed for DIY homeowners and repair technicians looking to restore precise thermal regulation to their washing machines. Its primary benefit is providing accurate feedback to the machine's control board, ensuring cycles reach the correct temperature for effective cleaning; however, users must verify their specific machine model compatibility, as sensor resistance profiles can vary between different appliance brands.
| Brand | SPARES2GO |
|---|
Symptoms include error codes on the display, cycles that never progress, or water that stays cold even when a high-temperature setting is selected.
It is a moderate repair task. If you are comfortable using basic hand tools and following safety procedures like disconnecting power, it is manageable.
A multimeter set to Ohms can be used to test if the sensor resistance changes as it is warmed, but physical inspection is the most common diagnostic step.
While it is compatible with many models, you should always verify your specific model number against the manufacturer's parts list before purchasing.
The sensor will not be in contact with the water inside the drum, resulting in an 'open' reading and failure to heat the water correctly.
Verify that the sensor is fully inserted and the wiring harness is securely connected.
Check the sensor with a multimeter to ensure it is showing resistance changes; if it is open-circuit or shorted, it requires replacement.
A faulty NTC sensor may not tell the machine when the water is hot enough; check the sensor for calcification or damage.
To install the sensor, first disconnect the washing machine from the power and water supply. Access the sensor by removing the back or front panel depending on your specific model; it is typically located near the heating element at the bottom of the outer drum. Carefully unplug the existing wiring harness, remove the old sensor, and press the new unit into the seal.
Ensure the rubber gasket is seated properly to prevent leaks. Compatibility is essential, so cross-reference your specific appliance model number against the compatible brands. There is no special maintenance required for this sensor, but keep the electrical contacts clean and dry during installation to ensure a solid signal connection.
