Permeable Driveway Paving Grid - Black

These grids are designed to stabilize ground surfaces, reinforce driveways and pathways, reduce rutting, and allow for permeable drainage, preventing waterlogging and soil erosion.

These grids are intended for use on natural ground surfaces like grass, sand, or gravel. They are not designed to be installed over existing hardscaping like concrete.

The recommended infill materials are grass, sand, or gravel, depending on your specific application and desired aesthetic. For grass applications, a suitable topsoil and seed mix is required.

You can clean the surface by sweeping or using a hose to remove dirt and debris. If filled with grass, standard lawn maintenance practices should be followed.

Each grid measures approximately 3.3 cm in height, 40 cm in width, and 60 cm in length.

Yes, they are designed to reinforce high-traffic areas, including driveways, and can support vehicle weight when installed correctly on a suitable substrate.

The gross weight of a single unit is approximately 0.798 kg.

Ensure the substrate base was adequately compacted and level before laying the grids. Check that the grids are interlocked properly and that the infill material is sufficient to hold them in place.

Verify that the substrate beneath the grids allows for adequate drainage. Ensure the grid cells are not completely blocked by infill material and that the overall ground slope directs water away.

Confirm that the correct infill material (grass, sand, or gravel) was used and that the grids are completely filled and compacted. The underlying base may need reinforcement if subjected to extreme weight.

Ensure the grass seed used is suitable for the climate and conditions. Make sure the grid cells are sufficiently filled with a quality topsoil/seed mix and that the grass receives adequate sunlight and water.