Setup, Compatibility & Care
To install, slide one of the included double wire clips over each section of the hose first. Force the hose end over the barbed joiner until it sits firmly against the center stop collar. Once positioned, move the wire clips over the area where the hose covers the barbs and tighten the screws until the connection is immovable.
- Compatibility: Only use with 50mm ID hoses. Always check if your hose type is prone to hardening in cold weather, which may require you to soak the hose end in warm water for easier installation.
- Care: Periodic inspection of the wire clips is recommended to ensure they remain tight, especially in outdoor settings where vibration or temperature fluctuations occur.