Best current price£5.98from B&Q
Shopping.co.uk recommended and popular offers
B&Q£5.98Visit shop B&Q - Jubilee Hose Pipe Clamps Clips Air Water Fuel Gas 20Pc Stainless Steel 1222mm
Visit shop1 offer from £5.98
View price history by clicking the chart icon.
Designed for both trade professionals and DIY enthusiasts, the AB Tools Jubilee Hose Pipe Clamps offer a robust, reliable solution for securing connections in air, water, fuel, and gas systems. These 9mm-wide stainless steel clamps provide exceptional tightening torque and resistance to environmental wear thanks to their protective zinc plating; however, users should ensure their hose outer diameter falls strictly within the 12-22mm range to ensure an airtight, secure fit.
| Model Part Number | AT855_2PK |
|---|---|
| Brand | AB Tools |
Yes, the stainless steel construction and zinc plating offer good resistance to moisture, though regular inspections are advised in saltwater environments.
Yes, these clamps are reusable provided the threads and the housing remain in good condition after removal.
Each pack contains 20 individual Jubilee clamps.
These are suitable for low-pressure gas applications, but always check local safety regulations for specific gas-fitting requirements.
This measurement refers to the outer diameter of the hose being clamped.
Verify that the hose diameter is within the 12-22mm range; if the hose is too small, the clamp will bottom out.
Ensure you are using the correct size flat-head screwdriver that fits the screw slot properly.
The hose may be too soft or the clamp is overtightened. Loosen slightly and ensure the band is sitting flat.
To install, slide the clamp over the hose before pushing the hose onto the fitting. Position the clamp approximately 5-10mm from the end of the hose for optimal sealing. Tighten the screw mechanism clockwise until firm.
Compatibility: These clamps are designed for hoses with a 12mm to 22mm outside diameter. Always measure your hose diameter with calipers if you are unsure.
Care: While the zinc plating provides significant rust protection, it is recommended to periodically inspect the screws for any signs of oxidation if used in marine or highly acidic environments. If a clamp shows signs of thread wear, replace it immediately to maintain system integrity.
