Wavin Osma Waste Push-fit Bend - 45 Degree - 32mm - Black

The Wavin Osma Waste Push-fit Bend is suitable for intermittent discharges of water up to 90°C. It is not designed for continuous high-temperature applications.

For standard installation, no specialized tools are typically required beyond ensuring the pipe ends are clean and potentially deburred. A tape measure or marker may be useful for insertion depth.

No, this product is specifically designed for waste water systems and is not suitable for potable (drinking) water applications.

The Wavin Osma Waste Push-fit system is available in 32mm, 40mm, and 50mm sizes, in black, grey, and white.

A watertight seal is achieved by ensuring the pipe is clean, free from obstructions, and pushed fully and squarely into the push-fit socket until it reaches the required insertion depth.

Push-fit offers significantly faster installation times, eliminates the need for primers and solvent cements, requires less cleanup, and allows for immediate testing of the system.

Polypropylene generally has good resistance to UV, but for extended direct sunlight exposure, it's advisable to protect the installation.

Ensure the pipe was fully inserted into the socket. Remove the pipe, check for debris or damage on the pipe end or inside the socket, clean both surfaces, and re-insert firmly. If damage is present, replace the component.

Check if the pipe end is clean, deburred, and of the correct diameter. A small amount of silicone-based lubricant (not petroleum-based) can be applied to the pipe end if needed. Ensure the pipe is being pushed in squarely.

While the bend itself is smooth, blockages often occur due to debris accumulation further down the system. Disassemble accessible sections of the waste pipework and clear any obstructions. The smooth bore of the Osma system helps minimize future blockages.