Setup, Compatibility & Care
Compatibility:
Mobil Super 2000 X1 10W-40 is designed for use in gasoline and diesel engines that do not have Diesel Particulate Filters (DPFs). Always consult your vehicle's owner's manual to confirm the recommended oil viscosity grade (10W-40) and API/ACEA specifications required for your specific engine. It meets or exceeds API SL/SM/SN/SJ/SN PLUS, AAE (STO003) group B7, ACEA A3/B3, and has approvals for VW 505 01, VW 505 00, AVTOVAS, and MB-approval 229.1.
Setup (Oil Change):
- Ensure the engine is warm but not hot.
- Safely lift and support the vehicle.
- Locate and remove the oil drain plug.
- Drain the old oil into a suitable container.
- Replace the drain plug, ensuring it is tightened correctly.
- Remove the old oil filter.
- Lubricate the rubber seal on the new oil filter with a little fresh oil.
- Screw on the new oil filter by hand until snug, then tighten an additional 3/4 to 1 full turn.
- Refill the engine with the correct amount and type of Mobil Super 2000 X1 10W-40 oil, as specified in your owner's manual.
- Start the engine and check for leaks. Allow the engine to run for a few minutes, then shut it off and recheck the oil level, topping up if necessary.
Care:
Regularly check the oil level and condition. Change the oil and filter according to the intervals recommended in your vehicle's owner's manual. In severe driving conditions (e.g., frequent short trips, dusty environments, towing), it is advisable to change the oil more frequently. Store the oil container in a clean, dry place, away from direct sunlight and extreme temperatures.