Digital Single Phase kWh Meter 40A With LCD Display - Finder 7M.24.8.230.0001

This meter is designed for monitoring energy consumption in private or non-commercial applications, such as domestic settings, small businesses, or for tracking specific circuits, rather than for official electricity billing.

No, the Finder 7M.24.8.230.0001 is not MID certified, which means it cannot be legally used for billing purposes in most European countries.

The S0 pulse output consists of two terminals. Connect these to your data logger or monitoring system according to the system's input requirements. The meter provides 1000 pulses per kWh consumed.

The meter has a nominal current (In) of 5A and a maximum current (Imax) of 40A. It also has a short-term overload capacity of 1200A for 10ms.

No, this is specifically a single-phase energy meter designed for L-N connections.

This energy meter has an accuracy class of B for active energy measurement.

The meter is powered by the 230V AC supply passing through it. No separate power supply is needed for its operation.

Verify that the power supply (230V AC) is correctly connected to the line (L) and neutral (N) terminals. Ensure the circuit breaker for that line is switched on.

Check the line and neutral connections. The meter is directional; ensure power flows from the input terminals to the output terminals as expected.

Confirm that the S0 output terminals are correctly wired to your monitoring device. Ensure the connected device is configured to receive S0 pulses and check the compatibility of the pulse rate (1000 Imp/kWh).

Ensure the meter is correctly rated for the connected load (up to 40A). Verify that no unauthorized modifications have been made and that the meter is within its operational temperature range.