Sambourne Connecting Bracket - Copper
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later.
Product Information
Full details
The Sambourne Connecting Bracket is an essential component for homeowners and contractors utilizing the Handrails Direct Sambourne system to create extended metal handrail runs. It offers a seamless, professional aesthetic by joining two 40mm poles end-to-end, though it is exclusively compatible with the Sambourne range and requires precise pole alignment for optimal stability.
All features
| Colour | Copper |
|---|---|
| Brand | Handrails Direct |
Extended Product Information
FAQs
Does this bracket fit other handrail brands?
No, this bracket is specifically designed for the Handrails Direct Sambourne 40mm pole system.
Do I need to drill into the rail to install this?
No, the bracket uses a concealed fix design, meaning no external drilling is required for the connection.
What tools are needed for installation?
You will generally need a screwdriver compatible with the provided screws and a measuring tape to ensure alignment.
Can this be used outdoors?
The bracket is designed for interior use; outdoor exposure may lead to tarnishing of the copper finish.
Are the screws included?
Yes, each bracket comes with all necessary screws and fixings required for assembly.
Troubleshooting
Joint feels loose or wobbly
Check that the internal screws are fully tightened and ensure the pole ends are cut perfectly square.
Pole does not slide over the bracket
Verify that you are using 40mm Sambourne poles and check the internal circumference of the rail for any metal burrs or debris.
Copper finish showing smudges
Gently wipe the surface with a microfiber cloth; avoid harsh detergents that may damage the copper plating.
Pros and Cons
Pros
- Elegant, high-quality copper finish
- Easy installation with included fixings
- Provides a clean, professional finish for long rail runs
- Integrated alignment ring ensures structural consistency
Cons
- Compatible only with 40mm Sambourne poles
- Requires precise measurement for accurate fit
- Not intended for load-bearing structural support outside the Sambourne system
Setup, Compatibility & Care
Installation requires standard hand tools and careful measurement of your 40mm poles. Ensure both pole ends are cut square for the best fit. To install, insert the bracket into the first pole, tighten the provided fixings, and slide the second pole onto the exposed side of the bracket until it meets the stop ring. For maintenance, clean the copper surface with a soft, dry cloth to prevent fingerprints or oxidation. Avoid using abrasive chemical cleaners that may strip the finish.