Next Natural Ticking Stripe Wallpaper - Brown

This wallpaper is made of non-woven paper. Use a high-quality, pre-mixed or powdered wallpaper paste specifically formulated for non-woven (paste-the-wall or paste-the-paper) applications. Follow the paste manufacturer's instructions.

While it can be used in general areas, it is not specifically designed for high-moisture environments like bathrooms. For best results and longevity, ensure good ventilation or consider a moisture-resistant sealant if using in a bathroom.

Measure the height of your wall and add approximately 10-15cm (4-6 inches) for trimming. Cut strips to this length. Ensure you account for pattern repeat when cutting subsequent strips.

The wallpaper is generally wipeable with a damp cloth for minor marks. It is not considered fully washable in the way vinyl wallpapers are. Avoid scrubbing or using harsh cleaning agents.

Carefully align the edges of each strip, paying close attention to the stripe pattern. Use a spirit level to ensure the first strip is perfectly vertical, as this will guide the alignment of subsequent strips.

The pattern is printed on high-quality non-woven paper, offering good durability for standard interior use. The design itself is timeless and resistant to fading under normal light conditions.

Gently lift the affected edge and smooth it out towards the nearest edge using a wallpaper brush or seam roller. If the paste has dried, you may need to re-paste that section.

Carefully adjust the position of the strip before the paste sets. Ensure you are using the correct overlap or butt-joint method as recommended for this wallpaper type. Trim and re-hang if necessary.

Use a sharp, fresh blade in your utility knife or craft knife. Cut against a straight edge, such as a ruler or spirit level, for cleaner lines.

Wipe away excess paste immediately with a clean, damp cloth. Ensure the cloth is not too wet to avoid damaging the wallpaper surface.