Metsä Wood - Smooth Planed Whitewood Spruce Stick Timber - 2.4M - 34mm - 18mm

This Whitewood Spruce timber is not naturally treated for outdoor use. If you plan to use it outside, it must be properly sealed and treated with an appropriate exterior wood preservative, paint, or varnish to protect it from moisture, UV, and pests.

This specific stick timber measures 2.4 meters in length, 34mm in width, and 18mm in thickness. It is a PSE (Planed Square Edge) timber, meaning its dimensions are precise.

You can cut this timber with common woodworking tools such as a handsaw, jigsaw, miter saw, or circular saw. Always ensure your blade is sharp for clean cuts and use appropriate safety equipment.

No, this Metsä Wood Smooth Planed Whitewood Spruce Stick Timber (34mm x 18mm) is intended for light repairs, decorative purposes, and non-structural applications. It is not designed or rated for heavy load-bearing structures.

Yes, its smooth planed surface makes it ideal for painting, staining, or varnishing. For best results, ensure the surface is clean and dry, and consider a light sanding before applying your chosen finish.

Store any unused timber in a dry, cool, and well-ventilated indoor area. Lay it flat or stack it evenly to prevent warping, and keep it away from direct sunlight or extreme humidity changes.

`PSE` stands for 'Planed Square Edge'. This means the timber has been machined to have consistent, smooth, and square edges, providing a uniform profile that is easy to work with and join.

Ensure your saw blade is sharp and appropriate for wood. Score the cutting line deeply with a utility knife before sawing, or use masking tape over the cut line to minimize splintering.

Double-check your measurements against the repair area. If the timber is slightly too large, carefully sand or plane down the edges. If too small, a new piece may be required, or you might need to adjust the repair area.

Always pre-drill pilot holes for screws, especially in smaller timber sections like this. For nails, use a nail gun or gently tap to start, ensuring the nail is centered and not too close to the edge.

This often occurs due to changes in moisture content or improper storage. Ensure the timber was stored in a stable environment before installation. For minor warping, try to clamp and secure it firmly. For severe warping, replacement might be necessary.

Ensure the timber surface is clean, dry, and free from dust, grease, or previous finishes. Lightly sand the surface with fine-grit sandpaper (e.g., 180-220 grit) before applying the finish to create a better key.