Best current price£33.98from The Range
Shopping.co.uk recommended and popular offers
The Range£33.98Visit shop John Guest Speedfit Reducing Elbow 22 X 15Mm (Pack Of 3) - Grey
Visit shop3 offers from £33.98 - £43.66
View price history by clicking the chart icon.
The John Guest Speedfit Reducing Elbow Push Fit Fitting (22 x 15mm) is designed for plumbers and DIY enthusiasts needing to create quick, secure 90° bends between pipes of different sizes. Its key benefit is effortless, tool-free installation that can be up to 40% faster than traditional methods. A potential caveat is the need for specific inserts when connecting to certain plastic pipes.
| Model Part Number | 9790504103901 |
|---|---|
| Brand | John Guest |
No, the John Guest Speedfit Reducing Elbow is a push-fit fitting designed for tool-free installation. You simply push the pipe into the fitting.
You can use standard copper pipes (BS EN 1057) and compatible John Guest Speedfit PEX and polybutylene plastic pipes. Inserts are required for plastic pipes.
To remove the fitting, twist the release collar (located at the end of the fitting where the pipe enters) and pull the pipe and fitting apart. This can be done in seconds.
Yes, this fitting is suitable for use in both hot and cold water systems, including central heating applications.
This fitting reduces from a 22mm pipe connection to a 15mm pipe connection.
Yes, the fitting is constructed from non-toxic materials, resistant to corrosion and scale build-up, making it suitable for potable water systems.
This product is sold as a pack of 3 John Guest Speedfit Reducing Elbow fittings.
Ensure the pipe was pushed in fully and squarely. Check the pipe end for any damage or burrs. Remove the fitting, clean the pipe end, and re-insert firmly. If using plastic pipe, verify the correct insert is installed and the pipe is properly supported.
Confirm the pipe is the correct size and type for the fitting. Ensure the pipe end is clean, smooth, and free of debris or deformation. For plastic pipes, ensure an insert is not obstructing the entry.
Ensure the locking collar is clean and free from debris. Twist the collar firmly in the release direction (usually marked) while simultaneously pulling the pipe and fitting apart. If stuck, a gentle wiggle may help.
Verify that the pipe is of the correct specification and has not been deformed. Ensure the pipe has been pushed in far enough for the Grip & Seal collet to engage properly. Check that the collet is not damaged.
Setup: Ensure the pipe ends are clean, dry, and free from burrs or damage. For copper pipes, simply push the pipe end firmly into the fitting until it seats fully. For compatible plastic pipes (PEX, polybutylene), ensure you use the appropriate John Guest pipe inserts (sold separately) before pushing the pipe into the fitting. The connection is made instantly.
Compatibility: This fitting is designed for use with standard copper pipe (BS EN 1057) and John Guest Speedfit PEX and polybutylene plastic pipes. Always use the correct inserts for plastic pipe applications to ensure a secure seal and support.
Care: The fittings require minimal care. Periodically check connections for any signs of leakage, especially after initial installation or system pressure changes. Clean any external dust or debris with a damp cloth. Avoid using abrasive cleaners or solvents, as these could damage the plastic components.
