Loops 3 Gang Triple Light Switch - Screwless - Black Nickel - 2 Way

It's a single wall plate containing three individual switches, allowing you to control up to three separate light circuits independently.

2-way switching allows a light or group of lights to be controlled from two different locations (e.g., top and bottom of stairs). You need two 2-way switches to achieve this for one light.

Yes, provided the total load of the LED lights does not exceed the 10A rating of the switch. Compatibility with specific dimmable LEDs may vary.

This switch is designed to fit a standard single UK electrical backbox. It does not require a specialized or deep box.

Use a soft, dry cloth for regular dusting. For smudges, use a slightly damp cloth and dry immediately. Avoid harsh chemicals or abrasive pads.

Each gang on the switch has a maximum amperage rating of 10A, which is suitable for typical domestic lighting loads.

If you are comfortable and knowledgeable with UK domestic wiring regulations, you may install it yourself. However, for safety and compliance, it is recommended to use a qualified electrician.

Ensure the power supply is turned on at the fuse box. Double-check all wiring connections against the 2-way switching diagram. Verify the bulb or connected fixture is functional.

Check for loose wire connections at the switch and the light fitting. Ensure the total load does not exceed the 10A rating of the switch.

Power off the circuit. Gently test the mechanical action. If still stiff, there might be an obstruction or defect; consider replacement.

Verify that two 2-way switches are correctly wired to control the same light. Ensure the 'traveler' wires are correctly connected between the switches.