Primaflow Prima Classic Endfeed Fitting Reducer 15 X 10mm Long Tail (Pack Of 25)

No, these are specifically designed for copper pipes manufactured to EN 1057. They are not compatible with plastic, PEX, or push-fit systems.

WRAS (Water Regulations Advisory Scheme) approval means the product has been tested and meets the requirements of the UK Water Fittings Regulations, confirming it is safe for use with drinking water.

Yes, these fittings are manufactured to standards suitable for gas installations. However, always ensure you comply with all local gas safety regulations and use appropriate flux and soldering techniques for gas work.

You will need a pipe cutter, flux, lead-free solder, and a blowtorch (e.g., propane) for soldering.

Cleanliness of the pipe and fitting, correct application of flux, even heating of the fitting and pipe, and allowing the solder to be drawn in by capillary action are crucial for a strong, leak-free joint.

This fitting reduces a 15mm copper pipe connection down to a 10mm copper pipe connection.

Ensure pipes and fitting were clean, properly fluxed, and heated evenly. Re-heat the joint and apply more solder if necessary. Check for cracks or porosity in the fitting itself.

The joint may not have been heated sufficiently. Ensure even heating of the fitting body. Check that flux was applied correctly. Ensure pipes were fully inserted.

Avoid excessive direct heat on the fitting. Heat the pipe first, then the fitting. Use a controlled flame and heat evenly.