Best current price£84.00from Demon Tweeks
Shopping.co.uk recommended and popular offers
Demon Tweeks£84.00Visit shop AIM K Type Thermocouple Temperature Sensors - Exhaust Gas Temperature (EGT) Without Patch Lead
Visit shop3 offers from £84.00 - £86.95
View price history by clicking the chart icon.
The AIM Motorsport Exhaust Gas Temperature (EGT) Sensor (S-T-EGT) is designed for motorsport professionals and serious enthusiasts seeking highly accurate temperature readings from exhaust gases. Its key benefit is providing precise data crucial for engine tuning and performance optimization in demanding racing environments. A potential caveat is the requirement for specific AIM patch leads depending on your data logger or dash setup.
| Model Part Number | S-T-EGT |
|---|---|
| Brand | AIM |
This is a K type thermocouple sensor.
It is compatible with AIM Mychron Expansion, EVO4, EVO4S, TC Hub, MyChron4, and MyChron5, provided the correct AIM patch lead is used.
Yes, you need a specific AIM patch lead. A 712-DIN 4 pin patch lead is required for EVO4/EVO4S loggers, and a 712-DIN 3 pin patch lead is required for TC Hub or MyChron4/MyChron5 units.
The sensor typically screws into a bung or fitting in the exhaust system. The 2-pin male connector then attaches to the appropriate AIM patch lead.
While designed for EGT, K type thermocouples can measure a wide range of temperatures. However, its physical design and connector are optimized for exhaust gas monitoring in motorsport.
These are professional quality sensors designed to provide the most accurate readings possible for motorsport applications.
Verify the correct patch lead is used and securely connected at both the sensor and the data logger. Check that the sensor connector is clean. Ensure the input channel on the data logger is configured correctly for a K-type thermocouple.
Confirm the sensor is placed correctly in the exhaust stream. Re-check the input configuration on your logger. If the issue persists, the sensor may require calibration or replacement.
Inspect the 2-pin connector for bent pins or damage. If damaged, the sensor may need to be replaced. Contact AIM support for options.
Setup & Compatibility:
To use the AIM S-T-EGT sensor, ensure you have the correct patch lead for your specific AIM device:
Connect the sensor's 2-pin male connector to the appropriate patch lead, and then connect the other end of the patch lead to your AIM data acquisition system.
Care:
