Clarke X-Pro Cat170 Air Needle Scaler Kit - Clarke - X-Pro Cat170

The X-Pro CAT170 requires a pneumatic air compressor that can provide adequate airflow (CFM) and pressure (PSI) for effective operation. Consult the product manual for specific requirements, but a compressor rated for at least 5 CFM at 90 PSI is generally recommended.

The tool features three adjustable needle positions. Typically, there's a mechanism (often a dial or sleeve) on the tool body that allows you to extend or retract the needles to achieve the desired aggressiveness and coverage.

Always wear safety glasses or a face shield, hearing protection, and gloves. Ensure proper ventilation and consider wearing a dust mask or respirator, especially when removing old paint or rust. Secure the workpiece firmly.

No, the Clarke X-Pro CAT170 is designed specifically for hard metal surfaces. Using it on softer materials like wood or plastic will cause damage.

It is recommended to lubricate the air tool daily or after approximately 2-4 hours of continuous use, depending on operating conditions. Use a dedicated air tool oil.

Please refer to the Clarke warranty documentation that came with your product or visit the official Clarke website for the most up-to-date warranty information.

Check air pressure from the compressor. Ensure the air hose is not kinked or blocked. Verify proper connection to the air source. Lubricate the tool with air tool oil.

Ensure needles are clean and free of debris or rust buildup. Verify that the surface being worked on is appropriate for needle scaler use. Inspect for damage and replace worn needles.

Inspect all connections and seals for damage. Tighten any loose fittings. If leaks persist, professional servicing may be required.