FloPlast FloFit+ Stem Reducer - 22mm x 28mm
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later.
Product Information
Full details
The FloPlast FloFit+ Stem Reducer is designed for professional plumbers and DIY enthusiasts who need a reliable, demountable connection when transitioning between 22mm and 28mm pipework in domestic plumbing. It provides a secure, efficient alternative to traditional copper fittings by allowing for quick assembly and disassembly in central heating or potable water systems. While it offers excellent versatility, users should ensure the pipe ends are perfectly clean and free of burrs to maintain the integrity of the O-ring seal during installation.
All features
| Model Part Number | 1264772 |
|---|---|
| Brand | FloPlast |
Extended Product Information
FAQs
Is this fitting suitable for use with copper pipe?
Yes, the FloFit+ system is designed to work with standard copper and compatible plastic pipework.
Can I reuse this fitting after removing it?
Yes, the FloFit+ is specifically designed to be demountable and reusable, provided the internal O-ring and collet remain in good condition.
Do I need to use jointing compound?
No, jointing compound is not required. The fitting uses an internal O-ring to create a watertight seal.
Can this be used on gas lines?
No, this product is intended strictly for water and central heating systems and should never be used for gas applications.
How do I ensure the connection is secure?
Always give the pipe a firm pull after insertion to ensure the internal grab ring has locked onto the pipe surface.
Troubleshooting
Joint is leaking immediately after installation
Ensure the pipe end is free of scratches and burrs, and verify the pipe is pushed fully into the fitting against the internal stop.
Difficulty inserting the pipe into the fitting
Check that the pipe is cut perfectly square and ensure the O-ring is not obstructed or twisted; lightly chamfer the end of the pipe.
Fitting is difficult to remove for maintenance
Ensure the system is completely depressurized; push the pipe slightly into the fitting to release tension on the grab ring before depressing the collet.
Pros and Cons
Pros
- Reusable and demountable design
- Compatible with potable water and central heating
- Requires no special soldering tools
- Effective in both hard and soft water environments
- High-quality, durable build standard
Cons
- Requires precise pipe preparation to avoid leaks
- Not suitable for use with non-standard pipe wall thicknesses
- Must be checked for secure seating after installation
Setup, Compatibility & Care
To ensure a long-lasting connection, follow these steps during setup:
- Ensure the pipe end is cut square and is free of any sharp burrs or debris that could damage the internal seals.
- Mark the pipe to the required insertion depth.
- Push the pipe firmly into the FloFit+ fitting until you feel it pass the O-ring and hit the stop.
- Pull back slightly on the pipe to confirm the 'grab' mechanism is engaged.
For care, periodically inspect the joint during routine system checks. Because it is a demountable fitting, you can remove it by depressing the collet, provided the system is depressurized first. Avoid using petroleum-based lubricants on the O-ring, as these can degrade the material over time.