Metsä Wood Smooth Planed Whitewood Spruce Stick Timber - 2.4M - 70mm - 44mm

This Metsä Wood timber is natural, smooth planed spruce and is generally recommended for indoor applications. If you plan to use it outdoors, it is essential to treat it with appropriate exterior-grade wood preservatives, sealants, or paints to protect it from moisture, UV radiation, and pests. Without treatment, its lifespan outdoors will be significantly reduced.

No, this specific timber product is not pressure-treated or chemically treated for rot or insect resistance. It is natural whitewood spruce with a smooth, planed finish. Any protection against environmental factors must be applied by the user.

For most projects, you will need basic woodworking tools such as a saw (hand, circular, or miter), a drill for pilot holes and assembly, a tape measure, a pencil, and sandpaper. Depending on your project, you might also use clamps, a router, or a planer.

Start by sanding the timber with medium-grit sandpaper (e.g., 120-150 grit) to remove any minor imperfections. Then, progress to fine-grit sandpaper (e.g., 180-220 grit) for a super smooth surface. Thoroughly remove all sanding dust before applying your chosen finish. For staining, a wood conditioner can help achieve a more even color.

PSE stands for Planed Square Edge. This means that all four sides of the timber have been machined (planed) to create a smooth surface and consistent, square edges. This process makes the timber easier to work with, join, and finish, as it provides uniform dimensions and a ready-to-use appearance.

Yes, this whitewood spruce timber is suitable for gluing. For strong, lasting joints, use a good quality wood glue (e.g., PVA wood glue) and ensure the surfaces are clean and free of dust. Clamp the glued pieces together firmly until the glue is fully cured according to the manufacturer's instructions.

Always store leftover timber flat, preferably on a few supporting battens or a flat pallet, to allow for air circulation and prevent direct contact with the ground. Keep it in a dry, covered area away from direct sunlight, extreme heat, or humidity changes to avoid warping or moisture damage.

This can sometimes occur due to variations in moisture content or storage. Store timber flat on an even surface in a dry environment. For minor warps, clamping the timber straight during assembly or cutting shorter sections can often resolve the issue. Always inspect timber before cutting.

Ensure your saw blade is sharp and appropriate for cutting wood. Using a dull blade can cause splintering or rough edges. Secure the timber firmly with clamps before cutting to prevent movement and improve accuracy. A higher tooth count blade can provide a smoother finish.

Splitting often happens when fasteners are too close to an edge or the timber's end, or if the fastener is too large. Predrill pilot holes slightly smaller than the screw's diameter. For nails, consider using a nail gun or blunting the nail tip slightly to cut rather than wedge the wood fibers.

Ensure the timber surface is thoroughly clean, dry, and free of dust, grease, or oils before applying any finish. Sand the surface smoothly (e.g., with 180-220 grit sandpaper) and wipe away all sanding dust. For stains, apply a pre-stain conditioner to highly absorbent wood like spruce to ensure an even absorption.