Plasplugs Hollow Door Anchors - Yellow - DR308

You will need a 6mm drill bit for proper installation.

These Plasplugs anchors are designed to accept No. 6 screws.

No, these anchors are specifically designed for hollow doors, thin panels, plywood, and fiberglass. They will not work effectively in solid walls like brick or concrete.

They are ideal for lightweight to medium-weight items such as decorative hooks, hangers, door blinds, and curtains.

These Plasplugs Hollow Door Anchors are sold in a pack of 10.

To remove, you can sometimes unscrew the item and then gently pull the anchor out. However, due to their expanding design, removal might damage the panel slightly, requiring minor repair.

No, once the expanding wings have deployed and gripped the panel, they are generally not designed for reuse and should be considered single-use.

This often happens if the drill hole is too large or if the anchor isn't fully seated. Ensure a precise 6mm hole is drilled and push the anchor firmly flush with the surface before tightening. If the hole is already too large, consider using a larger diameter hollow wall anchor (if suitable for the panel thickness) or patching the hole and re-drilling.

Verify you are using a No. 6 screw as specified. Smaller screws may not engage the multi-thread technology effectively, while larger screws may strip the anchor. Also, ensure the anchor is not damaged internally.

This usually indicates either the panel material is too weak for the applied load, or the screw was overtightened, stripping the anchor. Ensure the load is appropriate for hollow door anchors and avoid overtightening. For heavier loads, alternative fixing methods or reinforcement may be necessary.