Copper Press Fit Tee Reduced Branch - Vsh Xpress - 28mm x 28mm x 22mm

The primary advantage is the solder-free, press-fit installation method, which is faster, safer (no open flames), and more consistent than traditional soldering.

No, these fittings are specifically designed for use with copper tubes that comply with BS EN 1057 standards. Using other types of pipe will void the guarantee.

You will need a compatible VSH Xpress pressing tool with the correct jaw sizes for the diameters of the fitting you are using (e.g., 28mm and 22mm jaws for this specific tee).

The fitting has a triangulated socket design. If the fitting is not fully pressed onto the tube, this design allows water to escape during system testing, making the un-pressed joint immediately visible.

VSH Xpress fittings come with a 25-year guarantee when installed correctly with copper tube compliant to BS EN 1057.

Yes, VSH Xpress fittings hold WRAS and DVGW approval, confirming their suitability and safety for potable water applications.

No, once a VSH Xpress fitting is pressed onto a copper tube, it creates a permanent joint and cannot be reused. If removal is necessary, the fitting and a section of the pipe will need to be replaced.

Ensure the correct pressing jaw size is used for the fitting diameter. Verify the pressing tool is fully charged and operational. Check that the copper tube is inserted to the correct depth and is not damaged. Consult the pressing tool manual for troubleshooting steps.

The leak is likely due to an un-pressed or incompletely pressed fitting. Identify the leaking joint. If it's an un-pressed fitting, repress it correctly. If the fitting appears pressed but still leaks, the tube or fitting may be damaged; remove and replace the fitting and tube section.

Check the end of the copper tube for any damage, burrs, or deformation. Ensure the tube is round. Deburr and re-cut the tube end if necessary. Lightly lubricate the tube end and fitting socket with a compatible lubricant if recommended by the manufacturer.

This indicates an incomplete press. The fitting must be removed (if possible without damaging the tube) and replaced, or the entire pipe section should be replaced. Ensure the correct tool and jaw size are used for subsequent attempts.