Home Range Classic Bottle Trap - 35mm - Chrome Finish - Brass

First, place a bucket underneath the trap. Loosen the retaining nut on the adjustable outlet pipe, then unscrew the trap body. Carefully empty any collected debris into the bucket. Clean the inside of the trap with a brush and mild detergent, rinse, and reassemble, ensuring all seals are in place.

Refer to the manufacturer's documentation or the retailer's website for specific warranty information. Typically, brass plumbing fittings come with a manufacturer's warranty against defects.

While designed for basins, this bottle trap can be used in a kitchen sink if the waste outlet size is 35mm and it is an exposed plumbing setup. However, kitchen sinks often have higher flow rates and may encounter grease, which could require more frequent cleaning.

You will typically need a pipe wrench or adjustable pliers, a bucket, and potentially a sealant or PTFE tape depending on your existing pipework connections. A soft cloth for cleaning is also recommended.

It's advisable to check for leaks after initial installation and then periodically, perhaps every few months, or if you notice any unusual sounds or smells from the drain.

The height adjustment is primarily achieved through the positioning of the adjustable horizontal outlet pipe. The main body of the trap itself has a fixed height relative to the basin waste.

Check that all connections are securely tightened. Ensure seals and washers are correctly positioned and in good condition. If the leak persists, reassemble the trap, ensuring all parts are properly aligned.

The trap should prevent odors by maintaining a water seal. If odors are present, the water seal may have evaporated (if the sink is unused for a long time) or there might be a leak allowing gases to escape. Run water for a minute to refill the trap. Check for leaks and tighten connections if found.

The trap may be partially blocked. Loosen the retaining nut on the outlet pipe and carefully empty the trap's contents into a bucket. Clean out any debris from the trap body and outlet pipe. Reassemble and test.

The adjustable outlet pipe offers some flexibility. Ensure you are using the correct fittings for your specific drainage pipe. Minor adjustments to the trap's position or the angle of the outlet pipe may be needed. Consider consulting a plumber if significant mismatches occur.