LEXIVON Bike Torque Wrench - 1/4-Inch Dr. 15-Piece Kit

The wrench has a torque range of 2 to 26 Newton Meters (Nm), which is equivalent to 17.7 to 230.1 inch-pounds (in-lb).

The kit includes Hex bits (H2, H2.5, H3, H4, H5, H6, H8, H10), Torx bits (T10, T20, T25, T30), a 3-inch extension bar, and a 1/4-inch adapter.

The wrench ships pre-calibrated with a calibration certificate. For best results, always reset the torque to the lowest setting after use and store it in its case. Periodic recalibration is recommended if accuracy is in question.

This wrench is specifically designed and calibrated for bicycle torque specifications. While it has a 1/4-inch drive, its torque range is best suited for lighter bicycle components and may not be suitable for higher torque automotive bolts.

Wipe it clean with a dry or slightly damp cloth. Avoid using solvents. Store it in its case in a dry place. Always return the setting to the lowest value before storage.

A 72-tooth gear head allows for finer increments of movement (5 degrees per click), making it easier to operate and reach the desired torque in tight or confined spaces.

Push the button on the head of the wrench to release the socket. Push a new socket onto the drive until it clicks to secure it.

Ensure the torque is set correctly and the scale is properly engaged. Check that the correct bit is fully seated. If the issue persists, the tool may require recalibration.

Make sure the slide-to-lock mechanism on the handle is disengaged before rotating it. Ensure the handle is clean and free of debris.

Verify that the socket is fully inserted into the quick-release mechanism until it clicks. Ensure the quick-release button is not obstructed.

Use a light source to illuminate the scale. The highlighted yellow print is designed for better visibility, but direct light aids in low-light conditions.