Scheppach Belt and Disc Sander - BTS700

This unit is primarily designed for wood. Sanding metal creates fine, hot debris that can damage the sanding media and pose a fire hazard if mixed with wood dust.

Loosen the tension lever on the side of the belt unit, slide the old belt off, install the new one, and re-tension the lever before adjusting the tracking.

Typically, the unit includes basic sanding sheets for the disc and one belt, but it is recommended to have spares on hand for your specific project needs.

The sanding disc on the BTS700 has a diameter of 125mm.

While it can be operated without one, it is strongly recommended to use a vacuum to prevent dust accumulation, which can shorten the motor life and affect your health.

Adjust the tracking knob located on the side of the belt housing until the belt runs centered while the motor is spinning.

Reduce the feed pressure applied to the workpiece. The 250W motor is designed for light sanding; avoid excessive force.

Check that the unit is bolted or clamped securely to the workbench and ensure the sanding disc is properly seated on the backing plate.