Best current price£64.10from eBay
Shopping.co.uk recommended and popular offers
eBay£64.10Visit shop Varilight JDSE102S Screwless Brushed Steel 2 Gang Remote/Touch Master LED Dimmer
Visit shop
The Range£68.32Visit shop Varilight Jdse102s Dimmer Switch 2-Gang Brushed Steel - Brushed Steel
Visit shop5 offers from £64.10 - £74.17
View price history by clicking the chart icon.
This Varilight 2-Gang 1-Way V-Pro Multi-Point Remote/Tactile Touch Control Master LED Dimmer is designed for homeowners looking to add modern convenience and control to their lighting. Its key benefit is the ability to adjust dimming levels via touch control or a remote, enhancing ambiance and potentially saving energy. A potential caveat is that compatibility with all LED types should be verified, as with any dimmer.
| Colour | Silver |
|---|---|
| Model Part Number | JDSE102S |
| Brand | Varilight |
This dimmer uses V-Pro technology and is designed to work with most dimmable LED, incandescent, and halogen bulbs. For LEDs, ensure they are specifically marked as 'dimmable'.
The remote control should come pre-paired with the master dimmer unit. Ensure the remote has a working battery and is within the effective range of the dimmer. Refer to the product manual for any specific pairing instructions if needed.
The maximum load capacity for each of the two gangs on this dimmer is 100W. For LED loads, it is recommended to use between 1 to 10 LED bulbs per channel.
No, this dimmer is designed for dimmable bulbs only. Using non-dimmable bulbs can lead to flickering, buzzing, or damage to the dimmer and bulbs.
This is a master dimmer unit. For multi-point systems, refer to the Varilight V-Pro documentation for compatible slave units and wiring configurations.
Always turn off the power at the mains first. Clean the surface gently with a soft, dry or slightly damp cloth. Avoid using harsh chemicals or abrasive cleaners.
Please refer to the retailer or manufacturer's official documentation for specific warranty details, as these can vary.
Ensure the power supply to the dimmer is active. Check that the remote has a charged battery and is within range. Verify that the dimmer is correctly wired according to the installation manual.
This usually indicates incompatibility with the specific LED bulbs. Try replacing the bulbs with a different brand or model known to be compatible with leading-edge dimmers. Ensure the total load is within the dimmer's specified range (0-100W per gang).
Some warmth is normal, especially when operating near maximum load. However, if the dimmer becomes excessively hot, switch off the power and check the load. Ensure the load does not exceed 100W per gang and that the bulbs are compatible.
Confirm that power is supplied to the dimmer. If the power is on and the indicator still doesn't light up, there might be an internal fault with the dimmer.
Setup: Installation of this dimmer switch should be performed by a qualified electrician in accordance with current wiring regulations. Ensure the power supply is switched off at the mains before commencing any work. The master unit requires connecting to the lighting circuit, and if using multiple dimmers in a system, they must be wired correctly.
Compatibility: This dimmer is designed with V-Pro technology to be compatible with most dimmable LED, incandescent, and halogen light sources. However, due to the wide variation in LED driver designs, it is recommended to test a small number of your chosen LED bulbs with the dimmer before full installation, especially if using more than 10 bulbs. The load capacity per gang is 0-100W, specifically noting 1-10 LED bulbs within this range.
Care: To clean the dimmer, switch off the power supply at the mains. Use a soft, dry or slightly damp cloth to wipe the surface. Avoid using abrasive cleaners or solvents, as they can damage the finish. Ensure no moisture enters the switch mechanism.
