Best current price£13.99from B&Q
Shopping.co.uk recommended and popular offers
B&Q£13.99Visit shop - Brass Plumbing Fittings For Solder With Copper Pipes 18mm X 3/4Inch Inch Female Bsp
Visit shop1 offer from £13.99
View price history by clicking the chart icon.
This guide is for plumbers and DIY enthusiasts working with copper pipe installations. It details the B&Q Brass Plumbing Fitting, a 18mm x 3/4" Female BSP connector designed for securely joining copper pipes to threaded fittings via soldering, ensuring a watertight seal. A key benefit is its durable brass construction for longevity, though proper soldering technique is crucial for a reliable connection.
| Brand | B&Q |
|---|
BSP stands for British Standard Pipe. It is a widely used standard for pipe threads, ensuring compatibility between male and female threaded components.
No, this fitting is specifically designed for use with copper pipes and soldering. It is not compatible with plastic pipe systems.
This fitting accepts 18mm diameter copper pipe on the compression/soldering end.
It means the threaded end of the fitting has an internal thread with a 3/4 inch nominal size, conforming to the British Standard Pipe thread pattern.
Threaded connections should be tightened firmly, but avoid over-tightening, which can damage the threads. Always use appropriate thread sealant tape or compound for a watertight seal.
No, flux is a separate consumable and is not typically included with plumbing fittings. It must be purchased separately.
This fitting is intended for water systems. For gas lines, always use fittings specifically rated and approved for gas applications.
Reheat the joint, ensure surfaces are clean, apply flux, and re-solder. Ensure adequate solder was used and flowed correctly.
Disassemble the threaded connection, clean the threads, reapply PTFE tape or sealant, and tighten securely.
Ensure the pipe and fitting are thoroughly cleaned and fluxed. Check that the heat source is adequate and applied correctly to the base of the joint.
Verify that the copper pipe is indeed 18mm in diameter and that the fitting socket is not obstructed or damaged.
Setup: To install, ensure the 18mm copper pipe and the fitting's 18mm end are clean and free from oxidation. Apply flux to both surfaces. Insert the pipe into the fitting's socket. Heat the joint evenly with a blowtorch and apply solder to the opposite side of the joint, allowing capillary action to draw the molten solder into the gap. Once cooled, the 3/4" BSP female thread can be connected to a compatible male threaded component, using PTFE tape or appropriate pipe sealant on the threads for a watertight seal.
Compatibility: This fitting is designed for use with 18mm copper pipes and standard 3/4" BSP male threaded fittings. Ensure all components are compatible before installation.
Care: Brass fittings require minimal care once installed. Avoid harsh chemical cleaners that could damage the material or joint. Periodically check for any signs of leaks, especially in older installations.
