Best current price£13.97from B&Q
Shopping.co.uk recommended and popular offers
B&Q£13.97Visit shop B&Q - Sonoma Oak Light 90Cm X 1M Self-Adhesive Vinyl Wrap For Doors And Worktops
Visit shop2 offers from £13.97 - £14.49
View price history by clicking the chart icon.
This D-C-Fix Self Adhesive Vinyl Wrap in Woodgrain Sonoma Oak Light is designed for DIY enthusiasts and renters looking to quickly and affordably update surfaces like countertops, kitchen doors, furniture, and wardrobe doors. Its key benefit is providing a realistic woodgrain effect that can dramatically change a space's appearance without the cost of replacement. A potential caveat is the non-permanent nature, which, while beneficial for renters, means it may not be suitable for high-traffic, permanent installations without proper care.
| Model Part Number | 5056525324881 |
|---|---|
| Brand | D-C-Fix |
This vinyl wrap is suitable for smooth, clean, and dry surfaces such as kitchen doors, drawer fronts, wardrobe doors, furniture, countertops, and other flat or gently curved non-porous surfaces.
Clean the surface with a damp cloth and mild soapy water. Avoid abrasive cleaners or scouring pads, which can damage the finish.
No, it is designed as a non-permanent DIY solution. It can be removed, especially when warmed with a hairdryer, making it ideal for renters or temporary applications.
Leftover residue can typically be removed using warm, soapy water and a soft cloth. For tougher residue, a small amount of adhesive remover or isopropyl alcohol might be effective, but test in an inconspicuous area first.
It is best applied to smooth, non-porous surfaces. Applying over textured wallpaper or peeling paint is not recommended as it may not adhere properly and could damage the underlying surface upon removal.
Yes, the product description highlights that the designs are authentic, and you will 'hardly believe it’s a vinyl film,' suggesting a high degree of realism in the woodgrain effect.
It features a water-based, low-tack adhesive that allows the vinyl to be repositioned during application. This makes it easier to achieve a bubble-free finish compared to stronger adhesives.
Gently lift the vinyl back to the point of the bubble/crease and reapply using a squeegee, ensuring firm pressure. For stubborn bubbles, a pinprick can release trapped air.
Ensure the surface is clean, dry, and free of dust or residue. Reheat the adhesive side with a hairdryer and press firmly onto the surface. Check if the correct side of the vinyl is being applied (the adhesive side).
Gently warm the vinyl with a hairdryer on a low setting to soften the adhesive before peeling. Pull slowly and at a shallow angle. Any remaining residue can be cleaned with warm, soapy water.
Warm the vinyl with a hairdryer to make it more flexible. Carefully stretch and smooth the vinyl around the edges and corners, using a squeegee to ensure a tight fit. Trim excess with a sharp craft knife.
Setup: Ensure the surface to be covered is clean, dry, and smooth. Remove any dust, grease, or debris. For best results, measure the area and cut the vinyl slightly larger than needed. Peel back a small section of the backing paper and carefully align the vinyl. Slowly peel the backing paper while smoothing the vinyl onto the surface using a squeegee or credit card, working from the center outwards to avoid air bubbles. For corners and edges, a hairdryer can be used to gently warm the vinyl, making it more pliable for a cleaner wrap.
