DeWALT SDS Plus Drill Bit - 6.5 x 160mm - DT9520-QZ

This drill bit is compatible with SDS Plus hammer drills.

You can use this drill bit on masonry, stone, concrete, and brick/block work.

The lifespan depends on the material and usage, but the superior carbide grade is designed for long life and greater durability.

The tip design is 160° for better bit penetration and longer life.

Insert the drill bit into the SDS Plus chuck and secure it by pulling back the chuck sleeve and releasing.

Clean the drill bit with a brush to remove debris after use.

Always wear appropriate safety gear, including eye protection and gloves.

Check if the drill is set to hammer mode. Ensure the bit is sharp and not worn. Try applying more pressure while maintaining a steady speed.

Reduce pressure and speed. Ensure the drill bit is the correct size for the material and application. Check for any obstructions in the drilled hole.

Reverse the drill to remove the bit. If it's still stuck, try using pliers to gently pull it out. Check the hole for any debris or obstructions.