Best current price£19.57from OnBuy.com
Shopping.co.uk recommended and popular offers
OnBuy.com£19.57Visit shop Soil Pipe 67.5 Degree Bend 110 Mm Inlet - Push Fit - Grey - Waste 8716936079455
Visit shop1 offer from £19.57
View price history by clicking the chart icon.
This DYKA Soil Pipe 67.5 Degree Bend is designed for homeowners and DIY enthusiasts undertaking waste water system installations or repairs. Its key benefit is the simple push-fit connection with a complete rubber seal, ensuring a watertight and secure joint with minimal effort. A potential caveat is that this specific bend is intended for soil pipe systems only and is not suitable for high-pressure applications. It offers a 67.5-degree angle, 110 mm inlet size, and is constructed from durable PVC in a grey finish.
| Model Part Number | 20035335 |
|---|---|
| Brand | DYKA |
A 67.5-degree bend is used to change the direction of a soil pipe run by a specific angle, often to navigate around obstacles or to create smoother transitions in pipework compared to sharper bends.
No, this bend is specifically designed for soil and waste water systems and is not rated for hot water or pressurized systems. It is made from PVC which may deform under high temperatures.
For basic installation, you primarily need a way to cut the pipe cleanly and potentially a chamfering tool. No adhesives or special joining tools are required due to the push-fit design.
Push-fit means the pipe simply pushes into the socket of the bend, where a rubber seal creates a secure, watertight connection. It's designed for quick and tool-free assembly.
While made of durable PVC, its suitability for underground use depends on local regulations and the specific application. It is primarily intended for above-ground soil and waste pipe systems within a building.
Access may be limited depending on the installation. If accessible, a plumber's snake or appropriate drain cleaning tools can be used carefully. Avoid harsh chemicals that could damage the rubber seal.
The weight of this DYKA Soil Pipe 67.5 Degree Bend is approximately 0.419 pounds.
Ensure the pipe end is clean, smooth, and chamfered. Lubricant (like silicone-based pipe lubricant) can aid insertion. Check that the rubber seal inside the bend is correctly seated and not damaged.
Disconnect the pipe and re-insert it firmly, ensuring it's fully pushed in. Check the rubber seal for debris or damage and ensure it's properly aligned. If the seal is damaged, the bend may need replacement.
Confirm that the pipe is the correct 110 mm diameter and that it's being pushed fully into the fitting. Check the integrity of the rubber seal; a worn or damaged seal may not grip the pipe sufficiently. Ensure the pipe is not being subjected to excessive external force that could dislodge it.
Setup:
Compatibility:
Care:
