Setup, Compatibility & Care
Installation is straightforward due to the inclusion of an SS M4 screw. Before installing, ensure your cabinet or drawer front is drilled to accommodate a single mounting point.
- Measure the center point where you want the handle located.
- Drill a hole through the cabinet front using a drill bit suitable for the M4 screw diameter.
- Insert the screw from the inside of the door/drawer into the back of the handle.
- Tighten until snug, being careful not to over-torque the screw.
For maintenance, use a soft, lint-free cloth to wipe the surface. Avoid abrasive cleaners or scouring pads, as they can scratch the polished nickel finish. A mild solution of soap and water is sufficient to remove fingerprints or dust buildup.