Setup, Compatibility & Care
To achieve maximum performance, follow these steps:
- Drill: Use a 16mm masonry bit to drill a hole to the required depth in the solid concrete base.
- Clean: Use a wire brush and a pump or compressed air to remove all dust from the hole.
- Insert: Place the J-Fix capsule into the hole.
- Drive: Use a hammer or an SDS drill on the rotation-only setting to drive the stud into the capsule, which breaks the glass and mixes the resin.
- Set: Allow the specified curing time before applying any load to the stud.
These capsules are specifically compatible with concrete and solid stone. They are not intended for use in wet or water-filled holes unless the specific resin system is rated for saturated conditions.