Setup, Compatibility & Care
- Preparation: Ensure the pipes are clean and free of debris. Measure the pipe and use a saw to cut to the size needed.
- Application of Solvent Cement: Apply solvent cement evenly to both the inside of the adaptor and the outside of the pipe.
- Connection: Insert the pipe fully into the adaptor. Rotate the pipe slightly to ensure an even distribution of the cement.
- Holding Time: Hold the connection firmly for a few seconds to allow the solvent cement to set.
- Cure Time: Allow the joint to cure according to the solvent cement manufacturer's instructions. This usually takes around 30 minutes to an hour.
Compatibility:
The adaptor is designed for use with 32mm PolySoil® pipes and fittings from Polypipe. Always check compatibility before installation.
Care:
No specific care is required. Just ensure the pipe is correctly installed to ensure no leaks and an effective waste disposal system.