Rycote 15cm Super-Softie - 19/22

It is designed exclusively for shotgun microphones with a diameter of 19-22mm, and whose slots are no further than 15cm from the microphone's front.

The 3D-Tex material, combined with an open-cell foam and cavity design, creates a barrier that effectively diffuses and dampens wind noise, especially at low frequencies, while allowing sound waves to pass through with minimal attenuation.

Yes, the Rycote 15cm Super-Softie has high immunity to rain-soaking and maintains excellent acoustic transparency in most wet situations.

No, this specific model is designed for microphones where the slots are located no further than 15cm from the front. Longer microphones or those with slots further back may not achieve an optimal fit or performance.

Clean the exterior gently with a slightly damp cloth. Avoid using harsh chemicals or abrasive materials. Ensure it is completely dry before storing or re-attaching to the microphone.

The main advantage is its superior performance in reducing wind noise, particularly low-frequency rumble, while maintaining better acoustic transparency and being more resistant to moisture than many traditional furry types.

Ensure the windshield is fully seated on the microphone and that the microphone's slots are not obstructed. Verify the microphone's diameter and slot placement meet the product's specifications.

Check if the microphone's diameter falls within the 19-22mm range. Minor looseness might occur with microphones at the lower end of the diameter range. Ensure the fit is snug enough to prevent air gaps.

Confirm the windshield is correctly aligned over the microphone's capsule area. Remove any debris from the 3D-Tex material. Ensure the windshield is not damp, as this can affect acoustic transparency.

While water-resistant, the material can become saturated in heavy rain. Allow the windshield to dry thoroughly between uses. Ensure there are no water ingress points around the microphone body not covered by the windshield.