Prym Eyelets with Washers - Silver - 11 Mm - Pack of 15

These eyelets are made of brass with a silver-colored plating.

You will need a hammer and the provided application tool. Place the eyelet through the fabric, add a washer on the back, and strike the tool with the hammer to secure them together.

Yes, the brass construction is rust-proof, making them suitable for various conditions, though prolonged extreme exposure may affect the plating over time.

Yes, they are suitable for fabric, leather, canvas, and similar pliable materials, provided the material can accommodate the 11mm diameter.

Each pack contains 15 eyelets and 15 matching washers.

The 11mm and 14mm eyelets are designed primarily for hammer application. Smaller sizes (4.5mm and 8mm) are compatible with VARIO pliers, but specific dies might be required for the 11mm size if using pliers.

The inner diameter is approximately 11mm (or 0.43 inches).

Ensure the hole punched in the fabric is the correct size. Make sure the eyelet and washer are properly aligned before hammering. Use a firm, consistent strike with the hammer.

The hole may be too large, or the hammer strike was not firm enough. Try repositioning the eyelet and washer and apply more force with the hammer. For best results, use a solid surface underneath.

Ensure you are using the correct application tool for the 11mm eyelets and that it is seated directly onto the eyelet post. Maintain a steady hand during hammering.

The fabric may be too thin or delicate for an 11mm eyelet, or the hole was punched too large. Consider using a reinforcing patch behind the fabric or a smaller eyelet size.