Harbour Housewares Corrugated Metal Roofing Sheets - 110 X 46Cm - Green - Pack Of 14

The roofing sheets are manufactured from galvanised steel, which provides strength and resistance to rust and corrosion.

One pack of 14 sheets provides approximately 7m² of coverage when used together.

No, the sheets are supplied without pre-drilled holes to allow for maximum flexibility in cutting and positioning them according to your project needs.

Yes, they are ideal for sheds, outbuildings, shelters, and other outdoor structures, offering a durable and waterproof solution.

No, ridge caps are sold separately. One pack of 5 Harbour Housewares Metal Roofing Ridge Caps is designed to fit one pack of 14 Roofing Sheets.

Clean the sheets with water and a mild detergent if needed. Avoid using abrasive cleaners or tools that could damage the protective coating.

Due to their galvanised steel construction and rust-resistant finish, these sheets are designed for exceptional long-lasting durability when properly installed and maintained.

Ensure you are overlapping by at least one full corrugation. Check that the sheets are not bent or damaged, which could hinder a smooth overlap.

Use self-tapping screws with neoprene washers designed for metal roofing. Ensure you are screwing into solid timber battens. Do not overtighten, as this can strip the threads or damage the sheet.

Verify that the roof has adequate pitch (slope) to allow water runoff. Ensure there are no dips or low spots where water can accumulate. Check that overlaps are correctly sealed.

Use a sharp drill bit designed for metal. Start with a pilot hole if necessary. Apply steady pressure and consider using a lubricant if the metal proves very hard to penetrate.