Qboard Liquid Wetroom Floor Former With Offset Drainer - (W)800mm (L)1500mm

The Qboard Liquid Wetroom Floor Former measures 1.5 meters in length and 0.8 meters in width (800mm).

While DIY installation is possible, professional installation is highly recommended to ensure correct leveling, waterproofing, and plumbing connections for optimal performance and longevity.

You can use most types of tiles, including ceramic, porcelain, and natural stone. Ensure you use a tile adhesive suitable for wet room environments and the specific tile material.

The offset drainer provides significant flexibility in planning your wet room layout, allowing you to position the drain away from the center, which can be beneficial for plumbing access or aesthetic design.

This product is the floor former; the drain fitting and waste pipe connections are typically sold separately and must be compatible with the former's outlet.

Clean the surface thoroughly with a damp cloth and mild detergent to remove any dust or debris. Ensure it is completely dry before applying adhesive or waterproofing.

Compatibility with underfloor heating systems should be confirmed with the underfloor heating manufacturer, ensuring the system is suitable for installation within a wet room floor former and tile adhesive.

Check that the former is perfectly level and that the drain is not blocked. Ensure the slope directs water towards the drain.

Clean any debris from the drain trap and check the waste pipe for blockages. Ensure the pipe has adequate fall.

Refer to the waterproofing membrane manufacturer's guidelines for repair. Ensure all seams and edges were properly sealed during installation.

This may indicate movement in the sub-base. Ensure the former was securely fixed and that appropriate tile adhesive was used.