Best current price£9.94from City Plumbing GB
Shopping.co.uk recommended and popular offers
City Plumbing GB£9.94Visit shop Plumbright White 28 X 22 X 28Mm Reducing Tee Plastic Spt67040m
Visit shop
B&Q£10.93Visit shop B&Q - White Plastic Push-Fit 28 X 22 X 28mm Reducing Tee Spt67040M
Visit shop2 offers from £9.94 - £10.93
View price history by clicking the chart icon.
The Plumbright 28x22x28mm Reducing Tee is an essential plumbing component designed for professional contractors and DIY enthusiasts who need to facilitate complex pipe transitions in domestic and light commercial water systems. Its primary benefit is the time-saving push-fit connection mechanism that eliminates the need for open-flame soldering, though users must ensure their pipes are cut cleanly and fully deburred to guarantee a leak-free seal. This high-quality plastic fitting is engineered for durability, pressure resistance, and strict compliance with safety standards.
| Model Part Number | Spt67040M |
|---|---|
| Brand | Plumbright |
Yes, it is designed for both plumbing and heating systems provided the operating temperature and pressure remain within the specified range for the plastic material.
Yes, this fitting is compatible with copper pipes, provided the copper is clean, smooth, and free of deep scratches or burrs.
While technically possible, it is recommended to use new fittings when modifying or repairing a system to ensure the integrity of the O-ring seals.
When using plastic pipe (like PEX or Polybutylene) with this fitting, a pipe stiffener or support insert is usually required to ensure a secure connection.
These fittings are WRAS and KITEMARK certified, ensuring they meet rigorous quality and safety standards for water supply systems.
The product is primarily intended for internal domestic or commercial use. Extended exposure to UV rays from direct sunlight may degrade the plastic over time.
Remove the fitting and inspect the pipe end for scratches or burrs. Re-cut the pipe end to be perfectly square and deburr, then re-insert firmly.
Ensure the pipe is the correct outer diameter and that the internal grab ring is not obstructed. Verify the pipe end has not been deformed during cutting.
Ensure the pipe is pushed fully into the fitting past the O-ring to the internal stop. Verify the correct size of the pipe is being used for the corresponding port.
To ensure a successful installation, first cut your pipe square using a pipe cutter—avoid using a hacksaw if possible, as it may leave rough edges that damage the internal seals. Once cut, you must deburr the end of the pipe and ensure it is free from scratches or debris. Insert the pipe firmly into the fitting until you feel it hit the internal stop.
This fitting is compatible with standard metric pipe sizes. While it is low-maintenance, it is recommended to periodically inspect accessible joints for any signs of weeping. If a system is left unused for long periods, check the integrity of the seals upon reactivation. Avoid using chemical pipe dopes or lubricants not approved for use with plastic push-fit systems, as these can degrade the rubber seals over time.
