Electric Fireplace - 70 Inch - 12 Flame Colours - 1800W

The fireplace is 70 inches wide. [Info needed: full dimensions - height, depth].

No, as an electric fireplace, it produces no actual flames or emissions and therefore does not require any special venting or chimney.

You can change both the flame color and brightness using either the control panel on the unit itself or the included remote control. Refer to your user manual for specific button functions.

Yes, the flame effect operates independently of the heating function. You can enjoy the visual ambiance without activating the heater.

An 1800W heater uses approximately 1.8 kilowatt-hours (kWh) per hour when running at full power. The actual cost will depend on your local electricity rates.

Installation difficulty varies by method. Freestanding is the simplest. Wall-mounted requires basic DIY skills. Recessed installation is more complex and often benefits from professional assistance to ensure proper wall preparation and wiring.

The fireplace typically comes with an infrared remote control. Make sure there's a clear line of sight between the remote and the fireplace's sensor for optimal operation.

1. Ensure the power cord is securely plugged into a working 120V outlet. 2. Check the circuit breaker for your outlet to ensure it hasn't tripped. 3. Confirm the main power switch on the unit is in the 'ON' position. 4. If using a remote, check its batteries and ensure there's no obstruction between the remote and the unit's receiver.

1. Verify the heater function is activated, either via the control panel or remote. 2. Check the thermostat setting; it might be set lower than the current room temperature. 3. Ensure the air intake and heat outlet vents are not blocked. 4. Allow a few minutes for the heating element to warm up.

1. Check the brightness setting; it might be set too low. 2. Ensure the unit is receiving adequate power. 3. If equipped with an internal motor for the flame effect, ensure it's not obstructed. 4. Power cycle the unit by unplugging it for 5 minutes and then plugging it back in.

1. Replace the batteries in the remote control. 2. Ensure there are no obstructions between the remote and the fireplace's sensor. 3. Try operating the unit directly from the control panel to confirm the unit itself is functional.

1. Turn off the heater function to determine if the noise is coming from the fan. 2. Check for any loose debris or obstructions around the air vents or inside the unit (ensure it's unplugged first). 3. If the noise persists and seems mechanical, contact customer support.