Best current price£14.48from Autodoc
Shopping.co.uk recommended and popular offers
Autodoc£14.48Visit shop BREMBO Brake Pad Wear Sensor MINI A 00 444 34359804833 Brake Wear Indicator,Brake Wear Sensor,Warning Contact, brake pad wear
Visit shop11 offers from £14.48 - £20.39
View price history by clicking the chart icon.
The Brembo Prime Line Brake Pad Wear Indicator Sensor (A 00 444) is designed for automotive technicians and vehicle owners who prioritize precision and safety in their braking maintenance. This essential component provides an accurate electronic warning when front brake pads reach their wear limit, effectively preventing rotor damage. A key caveat is that this sensor is application-specific, meaning it must be verified against your vehicle's make, model, and year to ensure the 910 mm cable length and connector match your existing harness exactly.
| Model Part Number | A 00 444 |
|---|---|
| Brand | Brembo |
No, brake pad wear sensors are designed as single-use components. Once the circuit has been triggered or the sensor has been subjected to high-heat operating conditions, it should be replaced.
No, the A 00 444 model is engineered specifically for front axle disc brake systems.
The length of 910 mm is specific to the routing requirements of compatible vehicles. If the cable is too short, it will stretch and snap during steering movements; if too long, it may rub against the tire.
Generally, no special tools are required beyond those used for standard brake pad replacement, though a flat-head screwdriver may help in releasing the old connector clip.
You must check the vehicle compatibility list using your specific make, model, and year against the Brembo A 00 444 part specification.
Check that the sensor is fully seated in the brake pad slot and that the electrical connector is pushed in until it clicks.
Verify that the cable is following the factory-designated routing path rather than taking a shortcut across suspension components.
Inspect the cable for any signs of pinching or damage from the wheel or suspension travel, and ensure the connector pins are clean and free of corrosion.
Before installation, always lift the vehicle safely using jack stands. The sensor snaps directly into a designated slot on the brake pad backing plate. Ensure the electrical connector is clicked firmly into the wheel-well harness port until you hear a clear 'click' to guarantee a moisture-resistant seal. Keep the area around the electrical connector free of brake dust and road grime before joining to ensure a clean electrical connection. Note that this part is a sacrificial component; it is intended to be discarded and replaced every time new brake pads are installed to ensure the sensor loop remains intact.
