AK Interactive 12014 Wolverine P.V.A. Glue 100ml - White

The primary advantage is the integrated drying accelerator, which significantly speeds up the bonding process compared to traditional white glues.

It is specifically recommended for polystyrene and foam. For other plastic types, especially dense or flexible ones, test on an inconspicuous area first, as results may vary.

The glue achieves a total cure in approximately 6 hours, but this can vary depending on the room temperature and the thickness of the applied glue layer.

The glue performs best when applied at temperatures between 10°C and 35°C with a relative humidity of no more than 70%.

Yes, the glue is designed to be dilutable with water to achieve a thinner consistency suitable for various applications.

Store the glue in its original container with the cap tightly sealed in a cool, dry place, away from direct sunlight.

While it offers high resistance, it is a P.V.A. glue and may not be fully waterproof. It is generally water-resistant once cured but prolonged exposure to moisture is not recommended.

Dilute the glue with a small amount of water until the desired viscosity is achieved. Test on a scrap piece first.

Ensure surfaces are clean and properly prepared. Apply sufficient glue and hold parts together for longer until the initial bond forms.

Verify that the ambient temperature is within the recommended range (10-35°C) and humidity is not exceeding 70%. Lower humidity and warmer temperatures (within range) will speed drying.

Apply a very thin, even layer of glue. Ensure parts are properly aligned immediately after application. Clean any excess very carefully with a damp cotton swab before it begins to dry.