Flexible Braided Pipe Tap Connector Hose - x2 (Pair) 15mm x 3/4" inch 12mm Bore 500mm

WRAS Approval signifies that the product has been rigorously tested and meets the high standards set by the Water Regulations Advisory Scheme, ensuring it is safe for use with drinking water and accepted by all water suppliers in the UK.

The 3/4" BSP thread on this hose measures approximately 1 inch in diameter. If your tap's thread measures 3/4 inch in diameter, you need the 1/2" version of the connector.

This product is generally intended for cold water applications. Always check the product specifications or manufacturer's guidelines for suitability with hot water systems.

The bore size of this specific hose is 12mm.

Clean the exterior of the hose with a soft, damp cloth. Avoid using harsh chemicals or abrasive cleaners, as these can damage the stainless steel braiding.

The hose is made from flexible braided material using the highest quality grade 304 long-life stainless steel.

This product is supplied as a pair (x2).

Ensure the thread is correctly aligned and not cross-threaded. Check that the washer (if applicable) is present and in good condition. Tighten the connection slightly, but avoid overtightening which can damage the seal.

Verify that the hose is not kinked or crushed. Check that the tap is fully open and that there are no blockages within the pipework or at the connection points.

While braided hoses are flexible, extreme cold can temporarily reduce flexibility. Ensure the hose is not under undue stress or being bent at too sharp an angle, which could compromise its integrity.