Best current price£17.32from Power Tools Direct
Shopping.co.uk recommended and popular offers
Power Tools Direct£17.32Visit shop Baridi Carbon Filters For Cooker Hoods Cf135 - Pack Of 2
Visit shop4 offers from £17.32 - £23.32
View price history by clicking the chart icon.
The Baridi Carbon Filters (DH430) are essential accessories for homeowners using compatible Baridi cooker hoods who need to maintain clean air and neutralise cooking odours in their kitchens. This pack provides a convenient two-filter replacement solution that ensures your appliance continues to operate efficiently by capturing grease and food smells. While these filters are highly effective at odour removal, users must ensure the physical dimensions match their specific cooker hood model if using them outside of the designated Sealey compatibility list.
| Model Part Number | DH430 |
|---|---|
| Brand | Sealey |
No, these carbon filters cannot be washed or reactivated. They must be replaced once they reach the end of their service life.
It is recommended to replace them every 3 to 6 months, depending on your cooking habits.
Carbon filters are only required for recirculating mode. If your hood is ducted outside, you do not need these filters.
If the filter is too small, air will bypass the carbon, resulting in poor odour removal. If too large, it will not fit the mounting bracket.
Yes, each purchase of the DH430 contains a set of two filters.
Ensure the filter is perfectly aligned with the mounting lugs and that no debris is obstructing the housing.
Check that the filter is seated tightly against the motor and that the grease filter is also clean, as a dirty grease filter can block airflow to the carbon layer.
To install these filters, ensure the cooker hood is turned off and the power is disconnected. Access the internal filter housing by removing the primary metal grease filters. Align the DH430 carbon filters with the motor housing—typically using a twist-and-lock motion—until they are firmly seated. Always verify that your model number is DH284, DH285, DH286, or DH287 for a guaranteed fit. If you are using these for a non-Baridi hood, measure your existing housing carefully; the filter must measure 134mm on the outer diameter and 129mm on the inner diameter to seal correctly. Avoid getting water on the carbon material, as it will destroy the filtration properties; these filters are strictly non-washable.
