Sealey O-Clip Single Ear Assortment 160pc - AB043SE

The O-clips are manufactured from DIN 1.4301 stainless steel, which offers good corrosion resistance.

You will need specialized O-clip pliers (also known as ear clamp pliers) to install and tighten these single-ear clips effectively.

The assortment contains approximately 160 pieces in total, distributed across eight different sizes.

The sizes range from Ø7-8.5mm up to 20.2-22.8mm.

While they provide a secure clamp, their suitability for very high-pressure systems should be assessed based on the specific application requirements and hose rating. They are generally intended for low to medium-pressure fluid or air transfer.

The assortment comes supplied in a partitioned plastic box, with each section holding clips of a specific size for easy identification and access.

This product is sold as a complete 160-piece assortment. Individual sizes are not typically available separately within this specific kit.

Ensure the correct clip size is being used for the hose and fitting combination. Verify that the O-clip pliers are functioning correctly and applying adequate pressure.

This can occur if excessive force is applied or if the clip is not properly seated. Ensure the pliers are used as intended and that the clip is not being over-tightened beyond its capacity.

Check if the clip size is appropriate and if the hose is correctly seated on the fitting. The hose material itself may be compromised or not designed for this type of clamping. Ensure the clip is applied evenly around the circumference.

Measure the outer diameter of the hose and the fitting. Refer to the size specifications provided for the assortment (e.g., Ø7-8.5mm) to find the closest match.