Best current price£21.45from eBay
Shopping.co.uk recommended and popular offers
eBay£21.45Visit shop Starchem 10pcs Self Adhesive Car Sound Deadening Pads 530mm x 190mm x 2mm
Visit shop5 offers from £21.45 - £39.95
View price history by clicking the chart icon.
The Starchem Car Sound Deadening Pads are designed for automotive enthusiasts and DIYers looking to minimize road noise, vibrations, and interior rattling. These self-adhesive bitumen sheets provide an effective acoustic barrier for vehicle panels, significantly improving ride quality and sound system clarity. While they offer excellent vibration dampening, users should note that complete installation requires careful surface preparation to ensure the adhesive bond holds effectively in varying temperatures.
| Model Part Number | Vehicle Sound Deadening Similar to Dynamat |
|---|---|
| Brand | Starchem |
This depends on the area of coverage desired. A 10-pack is typically enough for two front door panels; for a full floor or trunk, you will likely need multiple boxes.
No. Significant reduction in vibration is often achieved by covering 25% to 50% of the flat metal surface area.
No, the pads must be applied directly to the bare metal for the vibration dampening properties to work effectively.
They are designed for the vehicle interior and can handle standard cabin temperatures, but they should not be used in high-heat areas like engine bays.
While you can apply them by hand, using a small rubber roller will help ensure proper adhesion and remove trapped air.
The surface was likely not cleaned well enough. Remove the pad, clean the metal with an automotive wax and grease remover, and apply a new pad.
Use a seam roller to apply firm pressure across the surface of the pad to force trapped air out toward the edges.
For the best results, start by stripping the interior trim to expose the metal body panels. Clean the metal thoroughly with a degreaser to remove any factory wax, oils, or dust, as these will prevent the adhesive from bonding permanently. Once the surface is clean, peel the backing off the pad and apply it firmly, pressing from the center outward to eliminate air bubbles. A rubber roller is recommended to ensure maximum contact. These pads are compatible with most steel and aluminum vehicle body panels; however, they should not be applied to extreme heat sources such as exhaust systems or directly onto the engine block.
