Insulated Screwdriver Set with Voltage Tester - 1000V, 13 piece, VDE Certified

VDE certification indicates that the tool has been tested and meets stringent safety standards (EN 60900) for use on or near live electrical circuits up to 1000V.

Pull back the collar or sleeve on the handle, insert the desired bit fully, and then release the collar. The bit should lock into place.

Yes, the set can be used for general purposes. However, its primary advantage and design focus is on electrical safety.

The bits are made from durable S2 alloy steel, known for its strength and resistance to wear.

The voltage tester is designed for quick, basic checks and indicates the presence of voltage within its specified range. For precise measurements, a multimeter should be used.

Yes, the insulation is permanently bonded to the tool shaft. It is crucial to avoid any damage to this insulation as it compromises safety.

Please refer to the product packaging or manufacturer's website for specific warranty information, as it can vary.

Ensure the bit is fully inserted and the quick-change mechanism has properly engaged. Check for any debris in the bit holder or on the bit shaft.

Confirm that the circuit is live by testing on a known live source. Ensure the tester tip is making good contact with the conductor. Check for any damage to the tester tip or handle.

Verify you are using the correct bit size and type for the screw. Check the bit for wear or damage. Ensure sufficient downward pressure is applied while turning.

Ensure no components are obstructing the latch. Gently clean around the latch mechanism. If persistent, check for defects in the case.