Tile Rite - 12mm Square Notched Stainless Steel Trowel

This trowel is designed for thicker tile adhesives suitable for creating a substantial bed. Always follow the adhesive manufacturer's recommendations for application methods.

While primarily designed for floor tiles due to the thick adhesive bed, it could potentially be used for very large format wall tiles where a substantial adhesive layer is required, provided the wall substrate and adhesive are appropriate.

Clean the blade thoroughly with water after each use and dry it completely. Store in a dry environment to maintain its rust and corrosion resistance.

No, the 12mm square notch is specifically for creating a thick adhesive bed, ideal for large floor tiles on uneven surfaces. It may be too deep for smaller tiles or for thin-bed applications.

It means the handle is attached to the trowel blade using six strong rivets, ensuring a very secure and durable connection that resists flexing or breaking under pressure.

Hold the trowel at a consistent angle (typically 45-60 degrees) to the surface and move it with even pressure and speed. Ensure the adhesive is applied in a manner that allows the notches to cut cleanly into it.

Ensure the trowel blade is clean and free from dried adhesive. Check that the adhesive mixture has the correct consistency as per the manufacturer's instructions.

Verify that the trowel is held at a consistent angle (around 45-60 degrees) to the surface. Ensure the adhesive is applied generously enough to fill the notches properly.

Inspect the rivet points. If the handle becomes significantly loose, it may indicate a structural issue and the trowel should be retired.

Although stainless steel is rust-resistant, prolonged exposure to moisture or harsh chemicals can cause discoloration. Clean thoroughly and dry immediately after use. Minor surface rust can often be removed with a non-abrasive cleaner.