Kenable RJ45 Boots - Cat 5e - Red

These boots are designed for use with Cat 5, Cat 5e, and Cat 6 Ethernet cables terminated with standard RJ45 connectors.

No, these boots are primarily for cosmetic finishing and physical protection of the connector and cable end. They do not impact data transmission speeds or signal quality.

Slide the boot onto the Ethernet cable. It can be done before crimping the RJ45 connector or after, ensuring it covers the connector and retention clip. Some minor trimming of the boot's cable entry may be needed for a perfect fit.

RoHS (Restriction of Hazardous Substances) compliance means the product adheres to strict regulations limiting the use of certain hazardous materials during manufacturing.

While they might fit, these boots are specifically designed and tested for Cat 5e and Cat 6. Compatibility with newer, thicker cable standards like Cat 7 or Cat 8 is not guaranteed and may require significant modification.

The retention clip on an RJ45 connector is fragile and can easily break if snagged or bent, rendering the connector useless. The boot covers and protects this clip.

This pack contains 10 red RJ45 boots.

Ensure you are using the correct size boot for your cable type. For some connectors, you may need to trim the cable entry point of the boot slightly to achieve a secure fit.

Ensure the boot is fully slid over the RJ45 connector, covering the entire retention clip area. Some specific connector designs might not be fully covered.

This usually indicates the boot's cable entry is too large for the specific cable jacket. Consider using a boot designed for a smaller cable diameter or carefully trimming the boot's entry point to allow the connector's strain relief to grip the cable securely.