Shadow Foam Festool Mini T-Loc Systainer Foam Inserts - Green 30mm

These specific inserts are designed for the Festool Mini Systainer T-LOC 1 TL and Festool Mini Systainer T-LOC 3 TL models.

Arrange your tools on the foam, then use a sharp knife to trace their outlines and carefully cut away the foam. Peel away the cut sections to create custom compartments.

Yes, the 100% polyethylene foam is designed to be durable, impact-resistant, and resistant to water and common chemicals, making it suitable for demanding professional environments.

While the cutting process is permanent, you can often re-cut new sections or use the "cut and peel" method to adapt the existing foam to new tool configurations, though some indentations may remain.

Clean the foam by simply wiping it with a damp cloth. For tougher messes, a mild soap and water solution can be used, followed by rinsing with a damp cloth and air drying.

Yes, the foam is made from 100% polyethylene, and off-cuts are recyclable where local recycling facilities accept this type of material.

This particular product (Green 30mm) is 30mm thick. Other variants may be available in different thicknesses.

Use a very sharp utility knife or a dedicated foam cutting tool. Ensure you are making controlled, shallow cuts and peeling away layers rather than attempting to cut through completely in one pass.

The "cut and peel" method allows for iterative adjustments. You may need to trim a little more foam to achieve a tighter fit. Ensure the tool is placed accurately before cutting.

Verify that you have the correct Shadow Foam insert model for your specific Festool Mini Systainer T-LOC size (T-LOC 1 TL or T-LOC 3 TL). Ensure no packaging material is obstructing the Systainer opening.

Although the foam is odorless, residual odors can sometimes occur. Allow the insert to air out in a well-ventilated area for 24-48 hours. If necessary, wipe with a mild soap and water solution and air dry thoroughly.