Best current price£4.60from City Plumbing GB
Shopping.co.uk recommended and popular offers
City Plumbing GB£4.60Visit shop Plumbright Endfeed One End Branch Reduced Tee 28 X 28 X 15Mm 78764
Visit shop2 offers from £4.60 - £5.11
View price history by clicking the chart icon.
This Plumbright End Feed One End Branch Reduced Tee is designed for plumbers and DIY enthusiasts needing to create secure, leak-free junctions in hot and cold water systems. Its primary benefit is offering a reliable and cost-effective method for connecting copper pipes using traditional soldering techniques. A key consideration is that it requires separate solder and a blowtorch for installation.
| Model Part Number | 78764 |
|---|---|
| Brand | Plumbright |
An end feed fitting connects to copper pipe using solder and heat. The pipe is inserted into the fitting socket, and solder is melted around the joint, drawn in by capillary action to create a seal.
You will need a blowtorch for heating, solder wire, and flux specifically designed for copper pipe soldering. Pipe cutters and deburring tools are also recommended.
Yes, it is suitable for standard domestic hot and cold water systems. Ensure correct soldering technique for optimal pressure resistance.
It is approved for low-pressure home gas installations. Always follow local regulations and safety guidelines for gas pipework.
WRAS (Water Regulations Advisory Scheme) approval signifies that the product meets strict standards for use in public water supplies in the UK, ensuring it does not contaminate the water.
The Kitemark is a voluntary British certification mark indicating that the product meets relevant British Standards (BSEN1254: Part 1 in this case) and has undergone rigorous quality testing.
No, this is an end feed fitting and requires soldering. It is not compatible with push-fit connection systems.
The leak is likely due to insufficient heat during soldering or poor solder flow. The joint may need to be heated again and additional solder applied. Ensure the pipe and fitting were clean and properly fluxed.
This usually means the fitting is not hot enough. Remove the heat source and reapply heat evenly to the fitting until it is hot enough to melt the solder on contact. Ensure the pipe and fitting are clean and fluxed.
Check for any burrs or debris inside the fitting or on the pipe end. Ensure the pipe is cut square and deburred. Gentle manipulation may be required.
Setup: This fitting requires a clean copper pipe end inserted into the appropriate socket. Apply flux to both the pipe and the inside of the fitting socket. Heat the fitting evenly with a blowtorch, then introduce solder to the joint. The solder should be drawn into the gap between the pipe and the fitting by capillary action. Ensure the fitting is adequately heated before applying solder to achieve a complete flow.
Compatibility: Designed for use with standard copper pipes conforming to relevant British standards. Suitable for hot and cold water systems and low-pressure domestic gas installations. Requires compatible solder and flux for end feed fittings.
Care: Once installed and tested for leaks, the fitting requires no specific maintenance. Ensure the surrounding area remains free from excessive moisture or corrosive substances that could affect the copper piping over time.
