Best current price£45.00from Homebase
Shopping.co.uk recommended and popular offers
Homebase£45.00Visit shop D-C-Fix Terrazzo Sticky Back Plastic Vinyl Wrap Film 67.5Cm X 10M
Visit shop3 offers from £45.00
View price history by clicking the chart icon.
This d-c-fix Terrazzo Sticky Back Plastic Vinyl Wrap Film is ideal for DIY enthusiasts and renters looking to refresh surfaces affordably. Its key benefit is providing an authentic Italian terrazzo stone effect with an easy peel-and-stick application. A caveat is that while heat-resistant to 70°C, it still requires protection from hot pans and proper sealing around wet areas.
| Model Part Number | 67.5cm x 10m |
|---|---|
| Brand | d-c-fix |
The surface must be clean, dry, and smooth. Remove any dirt, grease, or old adhesive. A smooth, non-porous surface is essential for best adhesion.
Yes, this film can be used on kitchen work surfaces. However, it's important to use mats for hot pans and food preparation, and to seal around wet areas like sinks with silicone to ensure durability.
Yes, it can be used in bathrooms on surfaces like vanity tops or cabinet doors. Ensure proper sealing around wet areas like the sink to prevent moisture damage.
The film is heat resistant up to 70°C (158°F).
Wipe the surface with a damp cloth and a mild detergent. Avoid abrasive cleaners or tools that could scratch the surface.
Yes, the film is repositionable during application. You can carefully peel it back and reapply it without compromising adhesion significantly.
While the film is wipe-clean, it's recommended to use separate cutting boards and trivets for hot items. Always seal edges around sinks and preparation areas.
Gently lift the film back to the point where the bubble started and reapply, smoothing out the air with a squeegee or credit card. For small bubbles, you can sometimes prick them with a fine needle and smooth them down.
Ensure the surface is clean, dry, and free from dust or grease. For some surfaces, a light sanding and cleaning might be necessary. Check that the protective backing has been fully removed.
When removing, try peeling slowly at a sharp angle. Gently warming the film with a hairdryer on a low setting can help soften the adhesive for easier removal, especially for older applications.
This indicates the temperature exceeded the 70°C limit. Always use heat-resistant mats or trivets for hot items. Minor surface discoloration might occur if overheated, and it may be difficult to repair.
Setup: Ensure the surface is clean, dry, and smooth before application. Peel back a small section of the backing paper and carefully align the film. Smooth down the applied section with a squeegee or credit card, gradually removing the backing paper as you go. If you make a mistake, gently peel back the film and reapply.
Compatibility: This film is suitable for a wide range of smooth, non-porous surfaces including kitchen doors, work surfaces, furniture, and other household items. It is not recommended for heavily textured, porous, or uneven surfaces.
Care: The film features a durable, wipe-clean surface. For routine cleaning, use a damp cloth with mild soap. Avoid abrasive cleaners or scouring pads, as these can damage the surface. Always use mats for hot pans and food preparation. Seal around wet areas such as sinks and hobs with silicone to prevent water damage.
